Mist Eliminators are separation devices, used throughout all kinds of Process Industries, to remove liquid droplets from gas and/or vapour streams. The most commonly used type is the ‘wire mesh’ mist eliminator, as it has no moving parts and requires a little (if any) or no maintenance. Our wire mesh demisters are available in a wide range of styles, sizes and shapes. Wire mesh demisters are made slightly oversized and are to be compressed at their rim surface when installed, to fit snugly into the vessel. In the Process Industry liquid mist, entrained in the product vapour, will undermines the process performance in several ways, such as: Loss of Valuable Liquids Loss in Overhead Vapour Quality Fouling and Corrosion of Downstream Equipment Catalyst Poisoning Reduction in Operating Capacities Unwanted Emissions from Vent Stacks Often, this requires vapour-liquid separation in e.g. knock-out drums, heat exchangers, overhead accumulators, evaporators, crystallisers, liquid-phase reactor vents, compressor feed surge drums, or others. BENEFITS, WHEN USING THE DEMISTERS:- * Higher separation efficiency * Increasing throughput capacity * Provides equipment protection * Reducing the loss of valuable chemicals * Prevents (air) pollution * Eliminate contamination * Improvement of product purity APPLICATIONS * Absorption columns * Distillation columns * Boilers and Scrubbers * Oil/water separators * Desalination units * Salt- and sugar industry * Desulphurization plants