Model: ST-105CAP
This machine can print any colourful label, human photo and scenery photo in the cap. It is widely used in advertise, gift, publicity, ect. Meanwhile, as for specialty which has appreciating value and pratical use in whole.
Feature
1. Electronic digital temperature indicator, automatic stable temperature.
2. Heat-resistant silica gel mad made the pressure more evenly, without transformed in 260.
3. Time controlled automatically.
4. Easy to adjust pressure.
5. Whole picture can be transferred in the cap.
Techique index
Voltage:220 to 110v Power:350w Temperature range: ( internal) 399 Time-controller:0 to 99.9 to 360 second Weight:11kg
Operation
Put a cap in the machine, put down the pressure handle ( adjust pressure to right place ) get ready of the power, press the power button (red), the indicator is lightened.
Note: The machine should be tightly connected with the ground.
1. Get ready of the power, and press the power button, then the power indicator is lightened.
2. Adjust the temperature to right range. When the temperature reaches the right degree, the indicator on the top of temperature adjuster switch off. Then the following operations can be conducted.
3. Adjust time controller to right time.
4. Flately place the cap on the platen, then cover the printing paper (please note the right surface of the paper)push the handle down to specified point. Please note that the force should be no more than 25kg at this time, otherwise, the handle will be transformed.
5. When the printing time is over, the buzzer noise, then lift the handle to where it was.
6. If you want to peel a cooled printing paper, you should brush the paper, then let it alone for 5 to 10 seconds before peel the paper. If you want to peel the hot printing paper, you can do it immediately after printing. Successful print requires right time, temperature and pressure. The thickness and material of the clothes, even the type of printing paper affect the performance of print. ( please ask your supplier about related information of the printing paper)
Maintenance:
1. Pressure: If the pressure is not enough or too much, you can tune the pressure-adjuster. Raise the pressure by turning the knob in clockwise and lower it in counter clockwise.
2. Time: If the temperature has reached specified value, but the buzzer does not noise or always noise and never stop, you should adjust it to right place.
3. Temperature: If the temperature up to the specified degree, the meter will points to 180 (within 5 minutes). If the reading meter raise but the heating platen is not heated, please check the electic circuits.
4. When the handle pushed down, but it lifted up automatically. Please adjust the knob down.
5. After the print is complated, the handle is hard to lift up, you may adjust the knob up.