Tang Hua-high-pressure
Specifications: 38 * 38CM 40 * 60CM (size of special models can be customized)

Features:

1, electronic digital thermostats control the temperature, high accuracy (plus or minus 2 ℃)

2, sophisticated surround the cast aluminum, fever and heating wire as one note, safe, durable heat evenly distributed:

3, heating panels include high temperature cloth Fangnian

4, electronic time control, the process is complete instructions

5, pressure regulation at any time

6, floor installation of high temperature silicone foam, the temperature reached 350 ℃

Technical parameters





Voltage;
Voltage
110V, 220V

Power;
power
2000W, 3000W

Temperature range;
Temperature range
0-399 ℃

Time;
Time range
0-60s

Table size;
Work table size
38 * 38CM, 40 * 60CM

Package dimensions;
Casing size
74 * 43 * 39 (CM), 74 * 65 * 39 (CM)

Weight;
Avoirdupois
25kg 40kg




Operational procedures:

Note:整机must have appropriate protection of solid ground.

1, hand into power, open the power switch, power indicator light was bright

2, will be required to adjust the thermostat temperature, the temperature reached that temperature, the thermostat upper part of the instructions Miediao, at this time to start work.

3, the time required to adjust the controller time.

4, will transfer under the label on the hot plate, Tang Hua Add on paper (Tang Hua attention to the front and back of the paper), will handle forced downward pressure until the end

Note: Do not force more than 30 kilograms, or may lead to handle deformation.

5, when the controller directed Hot Stamping time to time, the buzzer sound, to be brought up to handle in-situ ..

6, if it is cold tear the paper Tang Hua, please use the blackboard will be wiped clean once again balanced paper Tang Hua, such as 5 to 10 seconds, then Tang Hua torn away.

Note: If the tear is hot - Tang Hua, Hot Stamping finished Tang Hua paper please immediately removed. Successful Hot Stamping need to have the right temperature and pressure of time with each other and the thickness of clothing materials and Tang Hua affect the type of paper Hot Stamping to the effect. Tanghua ask your paper supplier for the Hot Stamping information.

Maintenance guide

1, the pressure: if the pressure of not enough or too large, adjustable knob for the surge, to increase pressure on the clockwise direction: Instead, just reduce the pressure:

2, temperature: When the temperature reached by the tune, with temperature control for the allegations by the adjusted figures showed that with the same number (about 10 minutes maximum), such as the temperature does not rise and boot-no fever, fever, please check the circuit.

3, Time: When the time arrived at the buzzer Hot Stamping ring or not ring continuously, if appropriate, will be adjusted to the appropriate location.

4, when handle pressure down at the end of each other, hand to open and handle automatic pick-up, please adjust Xuanniu downward adjustment.

5, Hot Stamping When completed, up to handle and hard feelings, can be adjusted downward adjustment Xuanniu.